Description
ProTaper SE Henry/Reed Bend Handlebar in Red – 7/8 Inch Powersports Bar
If you run a low bar position and want the bike to feel tucked-in and flickable through whoops and ruts, the Henry/Reed bend is built for exactly that riding style. This is a 7/8 inch ProTaper SE handlebar built for riders who like a low, flat-feeling sweep, and this particular unit is finished in a deep red anodized coat that matches red-accented graphics kits and number plates without looking mismatched next to OEM red plastics.
The SE series earns its reputation on a short list of real construction details:
- Crossbar clamps are CNC-machined from 6061 aluminum, not stamped, which keeps tolerances tight where the pad and clamp meet the tube.
- Tube is high-strength aerospace aluminum alloy rated at 70,000 psi, so it takes hard impacts and G-outs without folding or denting like a lower-grade bar.
- Works with standard 7/8 inch grips, throttle tubes and clamp-on accessories without needing bar-specific hardware.
- Bend geometry is measured and repeatable, so a replacement bar in the same part number sits exactly where your old one did.
This low-sweep profile keeps your wrists in a more neutral position when you are hanging off the bike in corners, and it is a favorite among riders who came up on flatter bars and never want to go back. Whether this is replacing a bar that finally gave out or you are building a fresh setup from the ground up, it drops into a standard 7/8 inch clamp without modification.
IPD Racing has stocked ProTaper handlebars since 2005 and only carries parts we would bolt onto our own bikes. Part number 025312, ProTaper SE Henry/Reed bend in red. Questions about fitment? Reach out to the IPD Racing team.
