Description
Bar height matters more than most riders admit until they spend a moto folded over a low, flexy setup. The Renthal RC High Twinwall gives taller riders and anyone who stands aggressively through whoops the extra height and control leverage that a standard bend cannot deliver, without turning the bar into a noodle on impact. This is the design that put Renthal on the map: a tube built inside a tube, an idea lifted straight from aircraft structural engineering, so the bar carries load the way a wing spar does rather than the way a single aluminum extrusion does.
- Twin-wall (tube-within-a-tube) construction for maximum strength versus a conventional single-wall bar
- Overall width 812mm for full leverage in whoops, ruts, and braking bumps
- Bar height 120mm with 86mm of rise, built for a taller, more upright stance
- 115mm clamp area matched to stock and aftermarket top clamps
- 58mm sweep and 187mm control length for a natural wrist angle at the grips
- Finished in black for a clean, race-team look on the bike
Renthal has been putting Twinwall bars under championship-winning riders since the design launched in 1998, and this RC High bend is one of the most requested heights in the lineup for a reason. It bolts straight into standard 7/8 inch clamps, so there is no adapter to source and no compromise to make. IPD Racing stocks it ready to ship for riders upgrading a stock bar or replacing one that finally met the ground too hard.
