Description
The Inertia Beadlock takes the guesswork out of running low tire pressure on rough terrain by clamping the bead mechanically instead of relying on air pressure alone. Instead of relying on air pressure alone to hold the tire in place, the beadlock ring bolts the bead down mechanically, so a soft tire stays seated even when it is flexing hard over rocks and ledges.
- A true beadlock ring clamps the tire bead mechanically to the wheel, holding the seal at pressures that would unseat a standard rim.
- ITP’s Rock Armor inner wheel lip reinforces the barrel so it resists bending and cracking under rock strikes and hard landings.
- Finished in matte black finish with machined accents for a look that matches modern UTV and ATV builds without competing with body graphics or accessories.
- Built in 14×7 with a 4×156 bolt pattern and 40mm offset for direct-fit installation on compatible machines.
- Retains the original Inertia styling cues while adding the hardware a beadlock setup actually needs to function safely.
- Gives riders the confidence to drop tire pressure for rock crawling, dune riding, or technical trail sections without second-guessing the bead seal.
This 14×7 Inertia Beadlock carries a 4×156 bolt pattern and 40mm offset in a matte black finish with machined accents, matched to the machines that spec was engineered around. Torque the ring bolts per the beadlock’s spacing pattern, check them again after the first few rides, and this wheel will keep low-pressure tires exactly where they belong through whatever terrain you throw at it.
