All Balls Racing – Hose & Clamp Kits - Kawasaki, including a full run of FS Hose and Clamp Kits built for Kawasaki fork service. Every fork rebuild needs the small vent, breather and drain lines replaced along with the clamps that hold them, and those are exactly the parts that get skipped: rubber hardens with heat cycles and fuel vapor, cracks at the barb, and starts pulling air or weeping right after you finished the job. These Kawasaki hose and clamp kits supply correctly sized lines and matched clamps so nothing is stretched over the wrong barb or clamped down with a screw-type worm gear that cuts the rubber. Fresh hose keeps pressure and venting behaving the way the system was designed to, which shows up as consistent damping, no unexplained fluid loss and a front end that stays predictable deep into a ride. Replacing hose while the fork or chassis is already open is the cheapest insurance in the whole job. Route the new lines clear of hot exhaust when you reassemble. Kit contents vary by application, so give us your Kawasaki model and year and we will confirm the right hose and clamp kit before you order.