Description
Switching from a stock 7/8 inch bar to a stronger 1-1/8 inch oversized handlebar usually means your triple clamp mounts will not fit anymore, and that is the gap the ProTaper Universal Solid Mount Kit closes. It adapts solid-mounted triple clamp bar mounts from 7/8 inch up to 1-1/8 inch so you are not forced to replace your entire clamp just to run a bigger bar.
- Adapts solid-mount triple clamp bar mounts from 7/8 inch to 1-1/8 inch diameter
- Precision CNC-machined from aircraft-grade aluminum for a tight, accurate fit
- Solid mounting design transmits maximum feedback for riders who prefer a firmer feel over rubber-mounted give
- Works with existing triple clamp hardware, no drilling or permanent modification needed
- Black finish matches most factory and aftermarket triple clamp setups
This kit is the practical route for riders upgrading bar diameter without a full clamp swap, and it is precise enough that installation does not turn into a fitting exercise. Going from 7/8 inch to 1-1/8 inch bar diameter adds real stiffness at the grips, which matters most for bigger riders or anyone who has bent a thinner bar in a crash before. Because this kit bolts onto your existing solid-mount clamp rather than replacing it, you keep your current bar height and offset exactly as set up, you are only changing what diameter of bar the clamp can hold. If you are unsure whether your current triple clamp is solid-mount or rubber-mount before ordering, check the mounting bosses or reach out to IPD Racing and we will help you confirm before you buy.
