Description
Not every SS wheel uses a metric bolt pattern, and this black and machined center cap is built for the 4×4 (4 on 4 inch) pattern found on a separate range of ITP SS wheels. It carries the same two-tone black and machined look as the metric-pattern versions, so switching between wheel sets on different machines does not mean a mismatched cap style stands out when the two are parked side by side.
- Direct-fit cap for ITP SS wheels drilled to the 4×4 pattern
- Black and machined two-tone finish for factory-correct styling
- Helps keep dirt, mud, and water out of the hub area
- Sold individually for single-wheel replacement
- Drops into the factory cap location without extra hardware
- Same styling family as other black and machined ITP SS caps
- Worth keeping as a spare for machines that run the 4×4 pattern
- Low-cost fix that avoids sourcing an entire replacement wheel
The 4×4 pattern shows up on certain ATV and UTV platforms that do not use the more common 4×110 or 4×137 metric spacing, so if your SS wheel measures out to four inches between bolt centers, this is the cap built for that setup. It replaces a cracked or missing original cleanly and keeps the two-tone finish consistent across the whole wheel set once installed.
